Sheet Metal Roofing Installation Guide

Always begin working at the point with the longest peak to eave distance.

Sheet metal roofing installation guide.

When laying the first sheet it should be offered onto the roof to get the purlins in the correct place as when fixing the sheets the screw will be in line with the purlins. The edging or eave flashing consists of metal strips that are used to cover the perimeter of. Add the metal panels. If yours do not then you will need to drill holes.

Most metal shingles will be attached to the roof using metal shingle. Take your first sheet. And for any exposed fasteners try to avoid over tightening them. Cut the panels to the desired length.

Depending on the area of the roof you can use different sized panels. You can either buy. Most panels come up to 32 feet 9 8 m in length. Allow for a minimum of 18.

Pre drill holes on the ridges. Installing your roofing 1. Buy the metal panels. Some panels have pre drilled holes.

For a single pitch roof the minimum pitch we recommend is 12 degrees tile form sheets must always be laid from right to left. You will use metal roofing screws to secure the metal panels to the sheathing. Work up from the initial row starting at the lower corner in a diagonal pattern staggering the shingles to prevent gaps. Moreover try to ensure that the screws are all aligned evenly.

Installing corrugated roofing 1. Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails.